YOUR BADGE
Department Personalization Process
At Hammer and Axe Leathercraft, we value the unique identity of each department. To ensure your badge cutout is a perfect match, kindly include your department / agency name in your order. In cases where your badge cutout is not in our system, we may request a few photos of your badge. Our precise laser-cut process ensures an accurate and customized fit. Your department's distinctiveness matters to us, and we look forward to personalizing your order to perfection.
Feel free to reach out with any questions or assistance needed throughout this process.
Required Photos
Please send us two photos of your badge upon request. One of the front and one of the back. Follow these steps and refer to the example for more information.
Front Photo:
-
Place your badge in the center of a piece of paper.
-
Measure the length and width of the badge from point to point in millimeters.
-
Record the size next to your badge.
-
Ensure the badge is sitting flat on the paper. If needed, wedge up the sides to make it flat.
-
Place a ruler next to your badge for scale.
-
Take a photo directly above the badge, keeping the border around the paper consistent.
Back Photo:
-
Repeat steps 1-5 from the front photo instructions.
-
Turn the badge over to show the back.
-
Take a photo directly above the badge, keeping the border around the paper consistent.
Make sure the lighting is good to capture clear and detailed images. If you have any further questions or need clarification on any step, feel free to ask!
